Welcome to Ampac

Ampac Brands

• FastSense
  • FastSense Plus
  • FastSense 100
  • FastSense 25
• FireFinder
  • FireFinder Multi-Loop FACP
  • FireFinder Multi-Zone FACP
  • FireFinder Series II
  • SmartTerminal Slimline LCDA
• LoopSense
  • Eight Zone Conventional Add On
• ZoneSense
  • ZoneSense
• ZoneSense PLUS
  • ZoneSense PLUS
• SmartGraphics
  • SmartGraphics
• Ancillaries
  • MultiAmp Power Supplies
    • MultiAmp 2A PSU
    • MultiAmp-DH 250mA Door Holder Supply
  • Analogue Devices
    • Discovery
    • XP95 Detectors & Devices
    • Single Input Device
    • Single Input Output Device
    • 3 Input Device
    • 3 Input Output Device
  • Beam Detectors
    • Fireray 2000
  • Conventional Detectors
    • Orbis
  • Door Holders
    • ADH-01 Surface Mounted Door Holder
    • DH1351 - Keeper Plate
    • DH1365
    • DH1368 - Flush Mounting Electro Magnetic Door Hold
    • DH1370/15 - 1370/30 - Electro-Magnetic Door Holder
    • H1330 - Magnetic Door Holder
    • H1369 Floor Mounted Electro Magnetic Door Holder
  • Visual Warning Devices
    • Strobe ASL-30
  • Manual Call Points
    • ACP-01 Manual Call Point
  • Audible Warning Devices
    • 150mm Fire Bell
    • 200mm Fire Bell

Ampac Solutions

• Conventional Fire Systems
• Intelligent Fire Systems
• Agent Release Systems
• High Sensitivity Detection
• Graphic Interface

Eight Zone Conventional Add On

The Eight Zone Conventional Board has been designed for the LoopSense range of fire alarm control panels, providing the ability to interface to conventional zones

FEATURES

• Allows LoopSense to support conventional detectors

• Ability to accommodate for up to 40 detectors per zone

• The board supports up to eight conventional zones, LoopSense can support up to four boards, resultantly providing for up to 32 conventional zones

• Supports Apollo Orbis, Series 60, Series 65, Hochiki, Nittan Sensortec and the Argus Aurora ranges of conventional detectors

• Features a programmable end of line (EOL) that allows for 3K3, 4K7, 6K8 and 10K resistor values or 10uF capacitor for use with head removal diode bases

• Maximum alarm current per zone is 25 mAs

• The zone interface circuitry is capable of recognising and reporting the following conditions:
1. Normal
2. Open Circuit
3. Short Circuit
4. Alarm

• Can be programmed to function in the following modes:
1. Normal (latching)
2. Non-latching/Self Reset
3. Dependency A, B and C (EN54-2 and AS7240-2)
4. Alarm Investigation facility